> For the complete documentation index, see [llms.txt](https://support.dlink.com.sg/llms.txt). Markdown versions of documentation pages are available by appending `.md` to page URLs; this page is available as [Markdown](https://support.dlink.com.sg/consumer/wi-fi-router/dir-835m/faqs/how-to-setup-ap-mode-for-d-link-dir-1253-dir-835m.md).

# How to setup AP mode for D-Link DIR-1253/DIR-835M

1. Connect your PC to the DIR-1253/DIR-835M router using an ethernet cable.
2. Access the router’s web interface by entering its IP address into a web browser on the address bar <http://192.168.0.1> then press enter.

<figure><img src="/files/eIKA0sP8Yg9Xw2gFizKf" alt=""><figcaption></figcaption></figure>

3. The page will be prompted to enter a username and password. The default username and the default password are:

   **Username**: Admin

   **Password**: (as printed on the device label bottom of the router)

   <mark style="color:$primary;">Note: If you have changed the password and cannot remember it, you will need to reset the router to factory defaults.</mark>
4. Once logged in, Click **home** at the top of the page, and then select **Internet setting.**

<figure><img src="/files/uWO1vhQKiMBQBcEYf536" alt=""><figcaption></figcaption></figure>

5. Select **Bridge mode** and click on **OK**

<figure><img src="/files/g1LRRsZibcPZEFlQCBG2" alt=""><figcaption></figcaption></figure>

6. Allow 1 minute for router to restart, once done, you are succefully setup DIR-1253/ DIR-835M in AP ( Access point ) Mode