> For the complete documentation index, see [llms.txt](https://support.dlink.com.sg/llms.txt). Markdown versions of documentation pages are available by appending `.md` to page URLs; this page is available as [Markdown](https://support.dlink.com.sg/consumer/wi-fi-router/dir-612/faqs/how-to-set-the-d-link-dir-612-as-repeater-mode.md).
# How to set the D-Link DIR-612 as Repeater mode
1. Connect your PC to the DIR-612 router using an ethernet cable.
2. Access the router’s web interface by entering its IP address into a web browser on the address bar then press enter.
3. The page will be prompted to enter a username and password. The default username and the default password are:
**Username:** Admin
**Password:** (as printed on the device label bottom of the router)
Note: If you have changed the password and cannot remember it, you will need to reset the router to factory defaults.
4. Once logged in, Click Internet at the top of the page, and then select **My Internet Connection is**: from the menu on the middle
5. Under **My Internet Connection is**, choose **Wifi extender** mode.
6. You need to key in the Wireless Network Password of the Main wireless network here and click on **Confirm**
7. DIR-612 will reboot for 50sec once you click on **connect**. Log in to the admin page again by the IP getting from main router once reboot done, it will show **Connected Successfully**, you are now successfully setup the repeater mode for your DIR-612.