How to install the DPN-BE7212GR Wi-Fi 7 Router via web GUI

1

If your internet connection is through an Ethernet cable from the wall instead of through an XDSL / Cable / PON modem, connect the Ethernet cable directly to the router's WAN port.

2

Connect your computer, smartphone, or tablet to the router either via Wi-Fi or using an Ethernet cable.

The default Wi-Fi password is printed on the label at the bottom of the router.

3

Once connected, open a web browser and type in the URL bar https://192.168.0.1 and hit enter.

You might see a "Privacy Error" or similar security warning. This happens because the router uses a self-signed SSL certificate, which browsers may not recognize as secure.

Here's how to proceed:

  1. Click on Advanced at the bottom of the warning page.

  2. Then, select Continue to 192.168.0.1 (unsafe) to access the router's login page.

If you’re hesitant to proceed due to security concerns, you can review the certificate details to verify its issuer and confirm that it is associated with D-Link.

To do this:

  1. Click the "Not Secure" icon or the padlock symbol (depending on your browser).

  2. View the certificate details to confirm it was issued by the D-Link manufacturer

4

Enter your admin username & password in their corresponding fields and click Login. The default username and password are printed on the router’s label at the bottom of the router. If you've set your own password, use that. Once entered, click Login to proceed.

Note: If you've forgotten the password, you can press the Reset button at the back of the router for 10 seconds to restore the router to its factory default settings, allowing you to reset the password.

5

Once you login to the router, you will see your current status of the router.

6

To start configuring the internet of the router, please select "Basic" then select “WAN” on the left-hand side.

For PPPoE:

  • Connection Mode: IPv4 / PPPoE

  • MTU: 1492

  • MVLAN: -1 (typically left as -1 unless specified by your ISP)

  • VLAN ID: Enter the VLAN ID provided by your ISP. If no VLAN is required, enter -1 (VLAN is disabled).

Note: Range: 1-4095, -1 (indicates VLAN is disabled)

  • PPPoE Account: Enter the PPPoE Account provided by your ISP.

  • PPPoE Password: Enter the PPPoE Password provided by your ISP.

  • Click Save/Apply at the bottom of the page.

For Dynamic IP (most common for cable or fiber ISPs):

  • Connection mode: IPv4 / IPoE

  • Select DHCP in the IPv4 address access mode

  • MTU: 1500

  • MVLAN: -1 (typically left as -1 unless specified by your ISP)

  • Enable NAT

  • VLAN ID: Enter the VLAN ID provided by your ISP. If no VLAN is required, enter -1 (VLAN is disabled).

Note: ▪ Range: 1-4095, -1 (indicates VLAN is disabled)

  • Click Save/Apply

PreviousHow to configure the wireless network name and password on DPN-BE7212GRNextHow to reset DPN-BE7212GR to its factory default settings

Last updated